Users Manual
Table Of Contents
- Utilities
- 8.1 Keypad Lock Options
- 8.2 Squelch Levels
- 8.3 Power Levels
- 8.4 Adjusting Display Brightness
- 8.5 Voice Operating Transmission
- 8.6 Setting Display Backlight Timer
- 8.7 Turning Radio Tones/Alerts On or Off
- 8.8 Turning Power Up Tone On or Off
- 8.9 Setting Tones/Alerts Volume Offset Levels
- 8.10 Turning Talk Permit Tone On or Off
- 8.11 Setting Languages
- 8.12 Turning LED Indicators On or Off
- 8.13 Turning Introduction Screen On or Off
- 8.14 Turning Voice Announcement On or Off
- 8.15 Turning Automatic Call Forwarding On or Off
- 8.16 Setting Menu Timer
- 8.17 Turning Analog Microphone AGC On or Off
- 8.18 Turning Digital Microphone AGC On or Off
- 8.19 Turning Intelligent Audio On or Off
- 8.20 Turning Acoustic Feedback Suppressor On or Off
- 8.21 General Radio Information
- 8.22 Received Signal Strength Indicator
- 8.23 Front Panel Programming
- 8.24 Viewing Enterprise Wi-Fi Certificate Details
- Authorized Accessories List
- Maritime Radio Use in the VHF Frequency Range
- Batteries and Chargers Warranty
- Limited Warranty
a To edit the numeric value of each digit, press
or . To enter and move to the next
digit, press .
2
Press to confirm the password.
If you enter the password correctly, the radio powers up.
If you enter the wrong password after the first and second
attempt, your radio shows the following indications:
• A continuous tone sounds.
•
The display shows Wrong Password.
Repeat step 1.
If you enter the wrong password after the third attempt,
your radio shows the following indications:
• A tone sounds.
• The yellow LED double blinks.
• The display shows Wrong Password and then, Radio
Locked.
• Your radio enters into locked state for 15 minutes.
NOTE:
In locked state, your radio responds to inputs
from the On/Off/Volume Control Knob and
programmed Backlight button only.
Wait for the 15-minute locked state timer to end and then
repeat step 1.
NOTE:
If you turn off and turn your radio on again, the
15-minute timer restarts.
7.21.2
Unlocking Radios in Locked State
Your radio is unable to receive calls in locked state. Follow
the procedure to unlock your radio in locked state.
Do one of the following:
• If the radio is powered on, wait for 15 minutes and
then repeat the steps in
Accessing the Radio by Using
Password on page 102 to access the radio.
• If the radio is powered off, power up the radio. Your
radio restarts the 15-minute timer for locked state.
A tone sounds. The yellow LED double blinks. The
display shows Radio Locked.
English
103