User's Guide
Table Of Contents
- Contents
- Supplier's Declaration of Conformity
- Important Safety Information
- Notice to Users (FCC)
- Notice to Users (Industry Canada)
- Software Version
- Intellectual Property and Regulatory Notices
- Computer Software Copyrights
- Radio Care
- Introduction
- Getting Started
- Radio Controls
- Status Indicators
- Zone and Channel Selections
- Calls
- Advanced Features
- 7.1 Talkaround
- 7.2 Monitor Feature
- 7.3 Home Channel Reminder
- 7.4 Remote Monitor
- 7.5 Bluetooth®
- 7.5.1 Turning Bluetooth On and Off
- 7.5.2 Connecting to Bluetooth Devices
- 7.5.3 Connecting to Bluetooth Devices in Discoverable Mode
- 7.5.4 Disconnecting from Bluetooth Devices
- 7.5.5 Switching Audio Route between Internal Radio Speaker and Bluetooth Device
- 7.5.6 Viewing Device Details
- 7.5.7 Deleting Device Name
- 7.5.8 Adjusting Bluetooth Mic Gain Values
- 7.5.9 Permanent Bluetooth Discoverable Mode
- 7.6 Radio Check
- 7.7 Scan Lists
- 7.8 Scan
- 7.9 Vote Scan
- 7.10 Contacts Settings
- 7.11 Call Indicator Settings
- 7.11.1 Activating or Deactivating Call Ringers for Call Alerts
- 7.11.2 Activating or Deactivating Call Ringers for Private Calls
- 7.11.3 Activating or Deactivating Call Ringers for Selective Calls
- 7.11.4 Activating or Deactivating Call Ringers for Text Messages
- 7.11.5 Assigning Ring Styles
- 7.11.6 Selecting a Ring Alert Type
- 7.11.7 Configuring Vibrate Style
- 7.11.8 Alarm Tone Volume Escalation
- 7.12 Dynamic Caller Alias
4
Press or to Scan State. Press to
select.
5
Press or to the required scan state and
press to select.
If scan is enabled:
• The display shows Scan On and Scan icon.
• The yellow LED blinks.
If scan is disabled:
• The display shows Scan Off.
• The Scan icon disappears.
• The LED turns off.
7.8.2
Responding to Transmissions During
Scanning
During scanning, your radio stops on a channel or group
where activity is detected. The radio stays on that channel
for a programmed duration known as hang time. Follow the
procedure to respond to transmissions during scanning.
1
If the Channel Free Indication feature is enabled,
you hear a short alert tone the moment the
transmitting radio releases the PTT button, indicating
the channel is free for you to respond. Press the PTT
button during hang time.
The green LED lights up.
2 Do one of the following:
• Wait for the Talk Permit Tone to end and speak
clearly into the microphone if enabled.
•
Wait for the PTT Sidetone to end and speak
clearly into the microphone if enabled.
3 Release the PTT button to listen.
The radio returns to scanning other channels or
groups if you do not respond within the hang time.
7.8.3
Deleting Nuisance Channels
If a channel continually generates unwanted calls or noise,
(termed a "nuisance" channel), you can temporarily remove
the unwanted channel from the scan list. This capability
does not apply to the channel designated as the Selected
English
72