User's Guide
Table Of Contents
- Contents
- Supplier's Declaration of Conformity
- Important Safety Information
- Notice to Users (FCC)
- Notice to Users (Industry Canada)
- Software Version
- Intellectual Property and Regulatory Notices
- Computer Software Copyrights
- Radio Care
- Introduction
- Getting Started
- Radio Controls
- Status Indicators
- Zone and Channel Selections
- Calls
- Advanced Features
- 7.1 Talkaround
- 7.2 Monitor Feature
- 7.3 Home Channel Reminder
- 7.4 Remote Monitor
- 7.5 Bluetooth®
- 7.5.1 Turning Bluetooth On and Off
- 7.5.2 Connecting to Bluetooth Devices
- 7.5.3 Connecting to Bluetooth Devices in Discoverable Mode
- 7.5.4 Disconnecting from Bluetooth Devices
- 7.5.5 Switching Audio Route between Internal Radio Speaker and Bluetooth Device
- 7.5.6 Viewing Device Details
- 7.5.7 Deleting Device Name
- 7.5.8 Adjusting Bluetooth Mic Gain Values
- 7.5.9 Permanent Bluetooth Discoverable Mode
- 7.6 Radio Check
- 7.7 Scan Lists
- 7.8 Scan
- 7.9 Vote Scan
- 7.10 Contacts Settings
- 7.11 Call Indicator Settings
- 7.11.1 Activating or Deactivating Call Ringers for Call Alerts
- 7.11.2 Activating or Deactivating Call Ringers for Private Calls
- 7.11.3 Activating or Deactivating Call Ringers for Selective Calls
- 7.11.4 Activating or Deactivating Call Ringers for Text Messages
- 7.11.5 Assigning Ring Styles
- 7.11.6 Selecting a Ring Alert Type
- 7.11.7 Configuring Vibrate Style
- 7.11.8 Alarm Tone Volume Escalation
- 7.12 Dynamic Caller Alias
• Perform data transmission.
• Press the programmed TX Interrupt Remote
Dekey button.
The recipient radio displays Call Interrupted.
6.6
Broadcast Voice Calls
A Broadcast Voice Call is a one-way voice call from any
user to an entire talkgroup.
The Broadcast Voice Call feature allows only the call
initiating user to transmit to the talkgroup, while the
recipients of the call cannot respond (no Call Hang Time).
Your radio must be programmed to allow you to use this
feature. Check with your dealer or system administrator for
more information.
6.6.1
Making Broadcast Voice Calls
Program your radio to make Broadcast Voice Calls.
1 Select a channel with the active group alias or ID.
2 Do one of the following:
• Select a channel with the active group alias or ID.
• Press the programmed One Touch Access
button.
3 Press the PTT button to make the call.
The green LED lights up. The display shows
Broadcast Call, the Group Call icon and alias.The
display shows the Group Call icon and alias.
4 Do one of the following:
• Wait for the Talk Permit Tone to end and speak
clearly into the microphone if enabled.
• Wait for the PTT Sidetone to end and speak
clearly into the microphone if enabled.
NOTE:
Users on the channel cannot respond to
Broadcast Voice Calls.
The radio returns to the previous menu after the call ends.
English
50