User's Guide
Table Of Contents
- Contents
- Supplier's Declaration of Conformity
- Important Safety Information
- Notice to Users (FCC)
- Notice to Users (Industry Canada)
- Software Version
- Intellectual Property and Regulatory Notices
- Computer Software Copyrights
- Radio Care
- Introduction
- Getting Started
- Radio Controls
- Status Indicators
- Zone and Channel Selections
- Calls
- Advanced Features
- 7.1 Talkaround
- 7.2 Monitor Feature
- 7.3 Home Channel Reminder
- 7.4 Remote Monitor
- 7.5 Bluetooth®
- 7.5.1 Turning Bluetooth On and Off
- 7.5.2 Connecting to Bluetooth Devices
- 7.5.3 Connecting to Bluetooth Devices in Discoverable Mode
- 7.5.4 Disconnecting from Bluetooth Devices
- 7.5.5 Switching Audio Route between Internal Radio Speaker and Bluetooth Device
- 7.5.6 Viewing Device Details
- 7.5.7 Deleting Device Name
- 7.5.8 Adjusting Bluetooth Mic Gain Values
- 7.5.9 Permanent Bluetooth Discoverable Mode
- 7.6 Radio Check
- 7.7 Scan Lists
- 7.8 Scan
- 7.9 Vote Scan
- 7.10 Contacts Settings
- 7.11 Call Indicator Settings
- 7.11.1 Activating or Deactivating Call Ringers for Call Alerts
- 7.11.2 Activating or Deactivating Call Ringers for Private Calls
- 7.11.3 Activating or Deactivating Call Ringers for Selective Calls
- 7.11.4 Activating or Deactivating Call Ringers for Text Messages
- 7.11.5 Assigning Ring Styles
- 7.11.6 Selecting a Ring Alert Type
- 7.11.7 Configuring Vibrate Style
- 7.11.8 Alarm Tone Volume Escalation
- 7.12 Dynamic Caller Alias
3 Secure the dust cover to the radio by pushing the
latch upwards.
2.6
Attaching the Accessory Connector
The accessory connector is to be secured to the universal
connector on the antenna side of the radio. Follow the
procedure to attach the accessory connector to your radio.
1 Insert the slanted end into the slots above the
universal connector.
2 Push connector upward.
3 Press downwards on the accessory connector until
you hear a click.
1
2
3
2.7
Turning the Radio On
Rotate the On/Off/Volume Control knob clockwise
until it clicks.
If successful, your radio shows the following indications:
• A tone sounds.
NOTE:
If the Tones/Alerts function is disabled, there is
no tone upon powering up.
• The green LED lights up.
• The display shows MOTOTRBO (TM), followed by a
welcome message or image.
• The Home screen lights up.
If your radio does not power up, check your battery. Make
sure that the battery is charged and properly attached.
Contact your dealer if your radio still does not power up.
English
25