User's Guide
Table Of Contents
- Contents
- Supplier's Declaration of Conformity
- Important Safety Information
- Notice to Users (FCC)
- Notice to Users (Industry Canada)
- Software Version
- Intellectual Property and Regulatory Notices
- Computer Software Copyrights
- Radio Care
- Introduction
- Getting Started
- Radio Controls
- Status Indicators
- Zone and Channel Selections
- Calls
- Advanced Features
3 Slide battery latch into lock position.
4 To remove the battery, turn the radio off. Move the
battery latch marked A into unlock position and hold,
and slide the battery down and off the rails.
A
NOTE:
This battery mismatch alert feature is only
applicable for IMPRES battery and Non‑IMPRES
battery with kit number programmed in Erasable
Programmable Read Only Memory (EPROM).
When the radio is attached with the wrong battery, a
low pitched warning tone sounds, the LED blinks in
red, and the Voice Announcement/Text‑to‑Speech
sounds Wrong Battery if the Voice Announcement/
Text‑to‑Speech is loaded by using CPS or RM.
When the radio is attached with a non-supported
battery, an alert tone sounds.
The certification of the radio is voided if you attach
a UL battery to an FM approved radio or vice versa.
Your radio can be preprogrammed in CPS to alert
you if this battery mismatch occurs. Check with your
dealer or system administrator to determine how
your radio has been programmed.
If your radio is attached with a non-supported or
wrong battery, immediately swap with the correct
battery.
English
19