User's Manual
Table Of Contents
- Contents
- Safety
- Introduction
- Batteries and Chargers Safety Information
- FCC Licensing Information
- Radio Overview
- Getting Started
- Programming Features
- Troubleshooting
- Use and Care
- Frequency and Code Charts
- Motorola Limited Warranty for the United States and Canada
- Accessories
- RM Series Features Summary
- Programmable Buttons Chart
- Icons Chart
- Blank Page
- Blank Page
- Blank Page
TROUBLESHOOTING
English
57
Limited talk range
Try This...
Steel and/or concrete structures, heavy foliage, buildings or vehicles decrease
range. Check for clear line of sight to improve transmission.
Wearing radio close to body such as in a pocket or on a belt decreases range.
Change location of radio. To increase range and coverage, you can reduce
obstructions, increase power. UHF radios provides greater coverage in
industrial and commercial buildings. Increasing power provides greater signal
range and increased penetration through obstructions.
Refer to See “Talking and Monitoring” on page 27.
Message not transmitted or
received
Make sure the PTT button is completely pressed when transmitting.
Confirm that the radios have the same Channel, Frequency, Interference
Eliminator Code and Scramble Code settings. Refer to “Talking and Monitoring”
section on page 27 for further information.
Recharge, replace and/or reposition batteries. Refer to “About your Li-Ion
Battery” section on page 14.
Obstructions and operating indoors, or in vehicles, may interfere. Change
location. Refer to “Talking and Monitoring” Section on page 27.
Verify that the radio is not in Scan. Refer to “Scan” on page 44 and “Nuisance
Channel Delete” on page 45.
Symptom