User's Manual
Table Of Contents
- Contents
- Safety
- Introduction
- Batteries and Chargers Safety Information
- FCC Licensing Information
- Radio Overview
- Getting Started
- Programming Features
- Troubleshooting
- Use and Care
- Frequency and Code Charts
- Motorola Limited Warranty for the United States and Canada
- Accessories
- RM Series Features Summary
- Programmable Buttons Chart
- Icons Chart
- Blank Page
- Blank Page
- Blank Page
PROGRAMMING
FEATURES
English
51
CLONING RADIOS
You can clone RM Series radio profiles from
one Source radio to a Target radio by using any
one of these 3 methods:
• Using a Multi Unit Charger (optional accessory),
• Two Single Unit Chargers (SUC) and a Radio-to-
Radio cloning cable (optional accessory),
• the CPS (free software download)
Cloning with a Multi Unit Charger (MUC)
To clone radios using the MUC, there must be
at least two radios:
• a Source radio (radio which profiles will be cloned
or copied from) and
• a Target radio (the radio which profile will be
cloned from the source radio.)
The Source radio has to be in Pocket 1 or 4
while the Target radio has to be in Pocket 2 or
5, matching in the MUCs pockets by pairs as
follows:
• 1 and 2 or,
•
4 and 5
When cloning, the MUC does not need to be
plugged into a power source, but ALL radios
require charged batteries.
1. Turn ON the Target radio and place it into one of
the MUC Target Pockets
2. Power the Source radio following the sequence
below:
• Long press the PTT button and SB2
simultaneously while turning the radio
ON.