User's Guide

PROGRAMMING
FEATURES
English
44
OTHER PROGRAMMING FEATURES
Scan
Scan allows you to monitor other channels to detect
conversations. When the radio detects a
transmission, it will stop scanning and will receive on
the active channel. This will allow you to listen and
talk to people on that channel without having to
change channel. If there are transmissions on
another channel once the radio has stopped
scanning then you will not hear that activity. After
activity has ceased on the channel which the radio
has stopped, scanning will resume again after 5
seconds of no activity on that channel.
•
By pressing the PTT button while the radio is
scanning, the radio will transmit on the channel
which was selected before Scan was activated.
If no transmission occurs within five seconds,
scanning will resume.
•
If you want to scan a channel without
Interference Eliminator Codes (CTCSS/DPL),
set the code settings for the channels to ‘0’ in the
CTCSS/DPL Programming Selection Mode.
Whenever the radio is set up in Scan, the
LED Indicator will signal a Red heartbeat.
•
To start scanning, press the SBx (x=1 or 2)
button (Scan has to be programmed to
either SB1 or SB2 via CPS). SB2 default to
Down Button for RMU2040/RMU2043/
RMM2050 models.
•
To stop scanning, short press the SBx
button again.