User's Guide

PROGRAMMING
FEATURES
English
38
Reading CTCSS/DPL Values
If you continue short pressing the PTT button
the radio will move forward to programming
CTCSS/PL Codes.
After hearing the current value for CTCSS/PL
Code you can scroll to a new code value
using the SB1 or SB2 button.
RM Series have up to 219 codes available
(refer to “Frequencies and Codes Charts”
Section).
Reading Auto-Scan Values
After hearing the CTCSS/DPL codes, short
press the PTT button and the radio will
advance to programming Auto-Scan.
Auto-Scan only has two values:
- Enabled
- Disabled
Note: While in Auto-Scan Mode, if you short press
PTT button, the radio will move forward to
programming the "Active Channels" feature, so
you can modify the amount of channels
available for your unit using the SB1 or SB2
button.
Saving Settings
If you are satisfied with the setting, you
can either:
•
short press PTT to continue
programming.
•
long press PTT to save and return to
'Idle' Programming Mode, or return to
normal radio operation if the radio is
already in idle mode or
•
long press the PTT button twice to exit
'Idle' Programming Mode and return to
the normal radio operation.
Note:
•
If you do not wish to save the value you just
programmed, turn the radio OFF.
•
If you ‘roll-over’ to the beginning of ‘Idle’
Programming Mode you will hear "Channel
#" and the LED Indicator will be a green
heartbeat again. All values that were
changed will be automatically saved.
•
If long PTT press or radio return to "Idle"
Programming mode, radio will save the
changes.