User's Manual

LED Indicators
LED Colour State Indication
Red Illuminated Radio is transmitting.
Blinking Battery voltage is low.
Green Illuminated Radio is receiving with PL/DPL disabled.
Blinking Radio is in active scanning mode.
Orange Illuminated Radio is receiving with PL/DPL enabled.
Blinking An error has occured.
On/Off and Volume Knob
• If the radio is off, turn this knob clockwise to turn
the radio on.
• If the radio is on, turn this knob counter-clockwise
to turn the radio off.
• Turn this knob clockwise to increase the volume.
• Turn this knob counter-clockwise to decrease the
volume.
Push-to-Talk (PTT) button
• Press and speak to microphone to send
message.
• Release and listen to receive messages.
Programmable Buttons
• The following functions are assigned as short press (press and release) or long press (press and hold for 1
second).
• The default functions assigned to your radio are described in the table below.
• If your dealer has re-programmed your radio’s programmable buttons, please enter the new functions in the
table below.
Button Function
High/Low Power Selects desired power level to High or Low.
Volume Set Allows you to check the audio and alert tone volume level.
Monitor Allows you to monitor the current channel for activity; disables squelch.
Sticky Monitor The radio monitors continually until you press this button again.
Scan Starts or stops channel scan.
Nuisance Channel
Delete
Removes unwanted channel(s) temporarily from scan list during scan.
Repeater/Talkaround Toggles your radio between functioning in Repeater mode or Talkaround mode.
PL/DPL Enables or disables your radio from requiring matching PL/DPL to receive messages.
Button Lock Locks or unlocks all buttons except PTT and On/Off/Volume Knob.
Battery Save Mode Toggles your radio between functioning with Battery Saver ON or Battery Saver OFF.
Squelch
Selects desired squelch level: Normal or Tight.
Unassigned No function is programmed to this button.
Press Type Programmable Button 1 Programmable Button 2
Short Press Monitor Scan
Long Press Sticky Monitor Nuisance Channel Delete
Press Type Programmable Button 1 Programmable Button 2
Short Press
Long Press
Speaker
• You will hear received messages through
the speaker.
Microphone
• Speak into the microphone when send-
ing message.
Accessory Connector
• Used to connect compatible
accessories to your radio.
Programming Port
• Lower port of radio.
• Use by your dealer to program
your radio.
Text.fm Page 2 Tuesday, December 28, 2004 12:21 PM