Installation Instructions

Table Of Contents

Chapter 4

Hardware Installation

This chapter contains information and procedures necessary for installing the 900 MHz eNodeB

cabinet.

For details on rack installation, including seismic procedures, see the Motorola Solutions Standards

and Guidelines for Communication Sites R56

manual.

For details on safety precautions, see General Safety Precautions on page 12.

4.1

Mounting the 900 MHz eNodeB Cabinet to the Floor

Prerequisites: Obtain:

• Anchors

IMPORTANT: If securing the rack to a concrete floor, use 1/4-inch grade 8 bolts with

anchors.

• Hammer drill and bit

•

Cabinet footprint (see 900 MHz eNodeB Cabinet Footprint on page 35)

IMPORTANT: Sites in seismic active areas may require additional bracing of the equipment

cabinets or racks. This manual does not contain specific procedures related to seismic bracing.

For further information, see the Motorola Solutions Standards and Guidelines for

Communication Sites R56

manual.

Procedure:

1 Carefully mark the mounting holes with a pencil as indicated on the rack footprint.

2 With a hammer drill and bit, drill the marked hole to the appropriate depth of the mounting

hardware.

3 Insert an anchor into the drilled hole.

4 Tap the anchor into place by using the hammer.

5 Carefully move the rack into the position indicated by the holes in the floor.

DANGER: Equipment racks are heavy and may tip. Use extreme caution when moving.

Lift from top eye nuts with the appropriate apparatus, or secure the rack against tipping if

lifting from the bottom. Failure to do so could result in death, serious injury or equipment

damage.

6 Adjust and level the cabinet feet using a hex driver or allen wrench from inside the cabinet to

align the mounting holes with the drilled holes. Each cabinet foot should be in direct contact with

the floor.

7 Secure the cabinet or rack to the site floor with the locally procured mounting hardware. Re-use

the load spreading washers that were used to assemble the lag bolts to the pallet.

TBD

Chapter

4 : Hardware Installation

Exhibit D page 35 of 38