Users Manual Part 2

13.1.3.3.8.2
Verifying Encryption Capability
When and where to use:
Verify that the MTS software is encryption-capable.
NOTICE: This content is applicable to 8.1 System Release and onward.
Procedure:
1 At the MMI command prompt, type ver and find the build number which follows the pattern
MTS_TSC_APP-R<X>.
Where <X> is a digit.
2 Check if the third digit in the software build number is equal to 4.
Step example: The third digit in build MTS_TSC_APP-R08.41.06 is equal to 4, thus the MTS
software supports encryption. In contrast, in the build MTS_TSC_APP-R08.11.06
the third digit
is not equal to 4, thus the MTS software does not support encryption.
13.1.4
Verifying Permanent Lock
Verify if the site is permanently locked before antenna maintenance work. Permanent lock is
maintained after resets and power cycles.
Prerequisites: You must be remotely logged on to the MTS.
Procedure:
1 In the Site Controller application, enter status sc.
The output containing the information: Internal State: AS_L_E_IDL (Permanently
Locked)
appears.
2 Enter status br.
A list of BR statuses appears:
========================== BR Status Information
===========================
Cab TX 1PPS Ref.Sign TX RX Current IP
& Pos Keyed Status Status Freq Freq Mode
Address
----- ----- ------ -------- -------- -------- -------------
-----------
01 01 N OK OK 000.0000 000.0000 N/A
10.0.253.11
01 02 N OK OK 000.0000 000.0000 N/A
10.0.253.12
3 Verify that the BRs' TX Freq and RX Freq equals 000.0000.
If any of the system outputs deviate from the description, the site is not permanently locked. For
details, see “Lock” in the MTS Man Machine Interface Commands manual.
6802800U74-AP
Chapter
13: MTS Troubleshooting
399