Users Manual Part 2

DPM 2 JTH0500105

Units are not present:

PSU 1 JTH0500200

Track ID not mapped:

JTH0500102

3 On the list, locate the unit that you have removed and that is indicated as Units are not

present.

4 Delete old CAN Bus unit from the CAN Bus unit mapping list. Use can remove_mapping

<Device>, where <Device> is the old unit name.

Step example:

SC> can remove_mapping psu 1

5 Add new CAN Bus unit to the CAN Bus unit mapping list.

NOTICE: The new unit Track ID is present on the replaced unit label and indicated as

Track ID not mapped in the list shown in step 2.

Use can add_mapping <Device><TrackID>, where <TrackID> is a Track ID of the new

unit and <Device> is the new unit name: psu X, where X denotes a digit between 0 and 2.

Step example:

SC> can add_mapping psu 1 JTH0500102

6 View the updated mapping list using the can check_mapping command and check that there

are no units labeled as Track ID not mapped

Units are not present .

6802800U74-AP

Chapter 11: Power Supply Unit

366