Users Manual Part 2

10.4.2.2
Reinstalling the Base Radio
Procedure:
1 Insert the replacement Base Radio by aligning the side rails with the appropriate rail guides
inside the Base Radio chassis.
2 Gently push the replacement module completely into the Base Radio chassis assembly using
the module handle(s).
3 Secure the replacement module using two TORX screws removed during module removal.
Tighten the screws to a torque of 2.7 Nm.
4 Reconnect the cables to the BR front plate.
5 Switch on the Power Supply Unit.
NOTICE: Do not perform this step when doing a hotswap.
6802800U74-AP
Chapter 10: Base Radio
356