Users Manual Part 2

Figure 208: M3 Screw position
6 Remove the Ribbon cable from the Module cage.
7 Mount the two brackets to the Module cage using 10 pcs. M4 screws.
8 Bend in the area at the back of the Module Cages for Ribbon cables to be routed through later.
15.7.1.2
Assembling the Module Cage in the MTS 4 Cabinet
Procedure:
1 Remove the Module Cage Beauty Plate (if any).
2 Mount all cables going from the lower Module Cage in your specific configuration and fix them
temporarily in the rack before mounting the air separator shelf and module cage.
NOTICE: This would typically be:
• Ethernet cables from Base Radio(s) in lower Module Cage to SC in upper Module Cage
(SC2).
• Ethernet cables from Base Radio(s) in upper Module Cage to SC in lower Module Cage
(SC1).
• CAN Bus cables to and from Filters.
3 Assemble the Air Separator shelf above the existing Module Cage using four M6 screws.
6802800U74-AP
Chapter 15: Expansion Options
474