Users Manual Part 2

• SC2: 2
• <yy:yy:yy:yy:yy:yy> = is the MAC address of the interface.
NOTICE:
eth0 and eth1 have different MAC addresses.
The IP addresses for each Site Controller must be different for eth0 and for eth1.
10 Check the IP settings on both SCs.
15.4.2.4
Configuring Site Controller IDs
NOTICE: The Site Controllers must have different ID values configured. To check the SC id,
follow the steps below.
Procedure:
1 Log onto the Site Controller Application MMI.
2 From the SC: prompt, run the command id.
3 An id value of either A or B is displayed.
4 Perform the same check on the second Site Controller.
5 If the IDs are the same, one of the ID values have to be changed. To do so, log onto the Site
Controller Application MMI.
NOTICE: It does not matter if it is the ID value of SC1 or SC2 that is changed, as long as
they do not have the same ID value.
6 From the SC: prompt, run the command id x where x can be either A or B. Make sure to define
a value different for the two Site Controllers.
7 Reset the Site Controller.
15.5
Expansion from Two-Channel to Four-Channel Cavity Combiner
It is possible to expand from a two-channel Cavity Combiner to a four-channel Cavity Combiner.
The order of an additional Cavity Combiner is dependent on the type of Cavity Combiner existing in the
current configuration of the MTS 4 cabinet. There are type of the Cavity Combiner:
• Auto Tune Cavity Combiner (ATCC)
• Manual Tune Cavity Combiner (MTCC)
NOTICE: The additional Cavity Combiner is delivered with the expansion kit that includes
required equipment and cables.
6802800U74-AP
Chapter
15: Expansion Options
467