Users Manual Part 2

Site Controller 2 (SC2)
• eth0: 10.0.254.2
• eth1: 10.0.253.2
Procedure:
For an MTS using a single Site Controller:
1 Check the Ethernet Settings by using the following command in the SC application prompt:
ifconfig -a
2 In the output, confirm that the eth0 and eth1 ports are configured correctly.
For single and double Site Controllers, set SC IDs by performing the following steps:
3 During start-up, log on to Boot1 of the Site Controller.
4 In the prompt, enter: spr inet/if/eth0
5 In the prompt, enter:
spr inet/if/eth1
6 Take note of the IP addresses and MAC addresses.
• If the IP addresses are set correctly, continue to step 10.
• If the IP addresses are set incorrectly, go to step 7.
7 Log on to Boot1 of the Site Controller.
8 In the prompt, enter:
spw inet/if/eth0 “dhcp:no addr:10.0.<third_octet>.<X>
mask:255.255.255.0 dev_name:tsec dev_unit:0 ethaddr:<yy:yy:yy:yy:yy:yy>
mtu:1500”
where:
• <third_octet> stands for:
• SC1: 253
• SC2: 254
• <X> stands for:
• SC1: 1
• SC2: 2
• <yy:yy:yy:yy:yy:yy> = is the MAC address of the interface.
NOTICE:
eth0 and eth1 have different MAC addresses.
The IP addresses for each Site Controller must be different for eth0 and for eth1.
9 In the prompt, enter:
spw inet/if/eth1 “dhcp:no addr:10.0.<third_octet>.<X>
mask:255.255.255.0 dev_name:tsec1 dev_unit:1
ethaddr:<yy:yy:yy:yy:yy:yy> mtu:1500”
where:
• <third_octet> stands for:
• SC1: 254
• SC2:
253
• <X> stands for:
• SC1: 1
6802800U74-AP
Chapter
15: Expansion Options
466