Users Manual Part 2

3066544B06 RJ45 Cable PSU2 / CAN1 CAN socket where terminator is sit-
uated (terminator to be removed
and replaced by the cable instead).
Could be on a filter or ATCC. In
case of no redundant Site Control-
ler, the terminator should be placed
in PSU 2/ CAN 2 output.
13 Switch ON the Power Supply Unit.
14 Check the LED indicators to verify the PSU is operating correctly.
15.2.2
Configuration
No configuration in itself is needed for the module cage, but the Power Supply Unit needs to be
configured and this is described in Updating the Mapping List with the New PSU TrackID on page 365.
Installation and configuration of additional Base Radios are described separately in Additional Base
Radio for Existing Module Cage in MTS 4
on page 453.
Furthermore, if an additional Site Controller is ordered as a separate expansion kit, it needs to be
installed and configured, see Redundant Site Controller on page 461.
15.3
Additional Base Radio for Existing Module Cage in MTS 4
It is possible to add a Base Radio into an existing module cage of the MTS 4.
NOTICE: The additional Base Radio is delivered with the expansion kit that includes required
equipment and cables.
6802800U74-AP
Chapter 15: Expansion Options
453