Users Manual Part 2

Alarm ID
Descrip-
tion
Recovery
Action
Clear Ac-
tion
Notes
the alarm is
cleared.
BRC hardware
failure or config-
uration prob-
lems.
ALM_TX_FINAL_FAILURE Power Am-
plifier final
failure.
The output
power is re-
duced by the
software.
If the alarm
condition
disappears
then the out-
put power is
restored by
the software
to the target
level.
The alarm may
be reported be-
cause of the
BRC hardware
failure or config-
uration prob-
lems.
• ALM_TX_VSWR_ALARM-
ING
• ALM_PA_VSWR_ALARM-
ING
Voltage
Wave
Standing
Ratio is
high.
No recovery
action taken
by the soft-
ware.
The alarm may
be reported be-
cause of the
BRC hardware
failure or config-
uration prob-
lems.
• ALM_TX_REFL_PWR_AL
M_FAULT
• ALM_PA_REFL_PWR_FA
ULT
Reflected
power is
high.
BRC is de-
keyed by the
software.
BRC stays
de-keyed
until reset
occurs.
The alarm may
be reported be-
cause of the
BRC hardware
failure or config-
uration prob-
lems.
•
ALM_TX_REFL_PWR_AL
M_WARN
• ALM_PA_REFL_PWR_W
ARN
Reflected
power is
high.
The output
power is re-
duced by the
software.
If the alarm
condition
disappears
then the out-
put power is
restored by
the software
to the target
level.
The alarm may
be reported be-
cause of the
BRC hardware
failure or config-
uration prob-
lems.
ALM_TX_KEYED_FWD_PW
R_LOW
The output
power drop-
ped below
60% of the
current tar-
get (pro-
grammed)
power (the
power level
that is ex-
pected to
be currently
set).
The power
leveling pro-
cedure is
executed to
get the out-
put power to
the expected
level.
When the
output power
is restored to
the expected
level the
alarm is
cleared
The alarm may
be reported be-
cause of the
BRC hardware
failure or config-
uration prob-
lems.
ALM_PA_OTHER_RF_FAIL The same as ALM_TX_KEYED_FWD_PWR_LOW
6802800U74-AP
Chapter 13: MTS Troubleshooting
415