Users Manual Part 2

Alarm ID
Descrip-
tion
Recovery
Action
Clear Ac-
tion
Notes
tion mes-
sage from
DSP.
ALM_PLAT_PEER_TIMING Timing /
clock fault
detected by
DSP - the
alarm is re-
ported as a
fault indica-
tion mes-
sage from
DSP.
No recovery
action taken
by the soft-
ware.
The alarm is
cleared after
de-keying
BRC.
The alarm may
be reported be-
cause of the
BRC hardware
failure.
ALM_PLAT_NO_EXP_CB No CoreLib
exception
callback set
in BRC Ap-
plication -
internal
software er-
ror
No recovery
action taken
by the soft-
ware.
The alarm is
cleared only
after reset-
ting BRC.
Software error
ALM_PLAT_NO_GEN_CB No CoreLib
command
complete
callback set
in BRC Ap-
plication -
internal
software er-
ror
No recovery
action taken
by the soft-
ware.
The alarm is
cleared only
after reset-
ting BRC.
Software error
ALM_PLAT_NO_EVT_CB No CoreLib
event call-
back set in
BRC Appli-
cation - in-
ternal soft-
ware error
No recovery
action taken
by the soft-
ware.
The alarm is
cleared only
after reset-
ting BRC.
Software error
ALM_PLAT_NO_RF_CB No CoreLib
DSP re-
ceive /
transmit da-
ta callback
set in BRC
Application
- internal
software er-
ror
No recovery
action taken
by the soft-
ware.
The alarm is
cleared only
after reset-
ting BRC.
Software error
ALM_TX_FINAL_FAIL-
URE_FLT
Power Am-
plifier final
failure.
BRC is de-
keyed by the
software.
If the alarm
condition
disappears
The alarm may
be reported be-
cause of the
6802800U74-AP
Chapter 13: MTS Troubleshooting
414