Users Manual Part 2
Alarm ID
Descrip-
tion
Recovery
Action
Clear Ac-
tion
Notes
• ALM_EX_NVM_CKSUM_F
AULT
• ALM_EX_NVM_CKSUM_F
AIL
Checksum
fault for the
Exciter
NVM pa-
rameters
was detec-
ted during
initialization
- some of
the Exciter
configura-
tion param-
eters may
be corrup-
ted.
Software at-
tempts to set
the parame-
ters to the
default val-
ues taken
from the de-
fault region
in the NVM
memory.
If the opera-
tion of re-
storing de-
faults is suc-
cessful the
alarm is
cleared. Oth-
erwise the
alarm status
is un-
changed.
Corrupted con-
figuration pa-
rameters may
cause that BRC
works incorrect-
ly. The default
values may be
different than the
lost parameter
values. To en-
sure that the pa-
rameters can be
restored man-
ually to the earli-
er backed up
values.
• ALM_TX_CLIP_DE-
TECT_ALM_FAULT
• LM_TX_CLIP_DE-
TECT_FAULT
Reported
when Jave-
lin clip de-
tected fail-
ure condi-
tion still ex-
ists after 1
minute.
BRC is de-
keyed by the
software.
BRC is re-
keyed by the
software. If
the alarm
condition
disappears
after key-up
then the
alarm is
cleared. If
the alarm is
reported for
the third time
it cannot be
cleared until
next BRC re-
set.
The alarm may
be reported be-
cause of the
BRC hardware
failure or config-
uration prob-
lems.
•
ALM_TX_CLIP_DE-
TECT_ALM_WARN
• ALM_TX_CLIP_DE-
TECT_WARN
Exciter Jav-
elin clip de-
tected.
The output
power is re-
duced by the
software.
If the alarm
condition
disappears
then the out-
put power is
restored by
the software
to the target
level. If the
alarm is re-
ported for
the third time
it cannot be
cleared until
next reset.
The alarm may
be reported be-
cause of the
BRC hardware
failure or config-
uration prob-
lems.
ALM_TX_TEMP_INTER-
NAL_WARN
Internal
Power Am-
plifier tem-
The output
power is re-
If the alarm
condition
disappears
6802800U74-AP
Chapter 13: MTS Troubleshooting
408