Manualshelf

Users Manual Part 1

ManualsBrandsMotorola Solutions ManualsElectronicsNon Broadcast Transmitter
919293949596979899100
2 Use the mounting plate as drilling template or mark the floor according to the dimensions shown
in Figure 22: MTS LiTE/MTS 2 – Drill Hole Position for the Mounting Plate on page 99 and
Figure 23: MTS 4 – Drill Hole Position for the Mounting Plate
on page 99. Remember to keep
the 13 mm distance behind the mounting plate. Four 12 mm holes are pre-drilled. Additional
holes may be drilled in the mounting plate where required.
Figure 22: MTS LiTE/MTS 2 – Drill Hole Position for the Mounting Plate
360
375
250
Figure 23: MTS 4 – Drill Hole Position for the Mounting Plate
480
500
360
13
3 Secure all mounting locations using nuts and lock washers.
4 Fully tighten all mounting nuts securing the mounting plate to the floor.
4.4.4.3
Securing Cabinet to a Mounting Plate
Procedure:
1 Move the MTS cabinet near to the mounting plate which has been fixed to the floor as described
before.
6802800U74-AP
Chapter 4: Hardware Installation
99