Users Manual Part 1

5 Move the MTS cabinet near to the mounting brackets.
6 Move the MTS backwards ensuring that the rear leveling feet of the MTS locate in the
corresponding cups in the rear mounting brackets.
7 Push the front brackets over the corresponding leveling feet and swing them until they engage
the screws.
8 Fully tighten the screws in the front brackets, see the following figure.
Figure 20: MTS – Mounting Brackets and the Cabinet
4.4.4
Installing the Cabinet Using the Mounting Plate
When and where to use:
Follow this process to mount the cabinet using the mounting plate.
Process:
1 Install the mounting plate to the floor, see Mounting Plate on page 97.
2 Secure the cabinet to the mounting plate, see Securing Cabinet to a Mounting Plate on page
99.
NOTICE: Recommended clearances are shown in Figure 7: Suggested MTS LiTE Site
Layout on page 66 for MTS LiTE, Figure 9: Suggested MTS 2 Site Layout on page 68 for
MTS 2, in Figure 11: Suggested MTS 4 Site Layout on page 70 for MTS 4, and in Figure
13: Suggested Expansion Cabinet Site Layout on page 72 for Expansion Cabinet.
4.4.4.1
Mounting Plate
NOTICE: MTS LiTE/MTS 2 and MTS 4/Expansion Cabinet mounting plates have different size
and hole positions.
6802800U74-AP
Chapter 4: Hardware Installation
97