Users Manual Part 1

drilled. The front brackets can be placed anywhere around the leveling feet at a radius of 60 mm

or 105 mm (either hidden under the cabinet, or stuck out for easy mounting), see the circles in

Figure 18: MTS LiTE / MTS 2 – Drill Hole Position for the Mounting Brackets on page 96

and

Figure 19: MTS 4 and Expansion Cabinet – Drill Hole Position for the Mounting Brackets on

page 96.

Figure 18: MTS LiTE / MTS 2 – Drill Hole Position for the Mounting Brackets

Figure 19: MTS 4 and Expansion Cabinet – Drill Hole Position for the Mounting Brackets

3 Secure the two rear brackets to the floor using one screw for each bracket.

4 Place 2 screws for each front bracket (2x2) in the drilled holes. Screw them almost all the way

down but leave space rotate the bracket into position later.

6802800U74-AP

Chapter 4: Hardware Installation