Users Manual Part 1

Figure 17: MTS – Mounting Brackets

4.4.3

Installing the Cabinet Using the Mounting Brackets

When and where to use: Perform this procedure to properly install the cabinet within the site facility

using the mounting brackets.

Procedure:

1 Check that the mounting brackets have been correctly positioned in the equipment room, see

Figure 7: Suggested MTS LiTE Site Layout on page 66 for MTS LiTE, Figure 9: Suggested MTS

2 Site Layout on page 68 for MTS 2, Figure 11: Suggested MTS 4 Site Layout on page 70 for

MTS 4, and Figure 13: Suggested Expansion Cabinet Site Layout on page 72 for Expansion

Cabinet site.

2 Mark and then drill the floor according to the dimensions shown in Figure 18: MTS LiTE / MTS 2

– Drill Hole Position for the Mounting Brackets on page 96 and Figure 19: MTS 4 and

Expansion Cabinet – Drill Hole Position for the Mounting Brackets on page 96. Remember to

keep the 13 mm distance behind the mounting plate. In each bracket, a 12 mm hole is pre-

6802800U74-AP

Chapter 4: Hardware Installation