Users Manual Part 1

4 Delete the old CAN Bus unit from the CAN Bus unit mapping list by entering: can
remove_mapping <X>.
<X>
identifies the old unit name and is digit between 0 and 3.
Step example: can remove_mapping dpm 2.
5 Add the new CAN Bus unit to the CAN Bus unit mapping list by entering: add_mapping
dpm<X><track ID>.
<track ID> is a Track ID of the new unit.
<X> identifies the new unit name and is a digit between 0 and 3.
NOTICE: The new unit Track ID is present on the replaced unit label and indicated as
Track ID not mapped.
Step example: can add_mapping dpm 2 JTH0500102
6 View the updated mapping list by entering: can check_mapping.
7 On the mapping list, check that there are no units labeled as Track ID not mapped or
Units are not present.
7.3.6
Cavity Combiner
NOTICE: MTS 2 does not support Cavity Combiners.
There are two types of Cavity Combiners available:
•
Auto Tune Cavity Combiners (ATCC)
• Manual Tune Cavity Combiners (MTCC)
MTCCs are functionally the same as ATCCs except that they are tuned manually instead of
electronically.
NOTICE: 260 MHz configurations does not support MTCC.
Minimum channel spacing of the TX channels is 150 kHz while the recommended channel spacing is
250 kHz. This limitation applies to all Cavity Combiners in all cabinets connected to the same transmit
antenna.
6802800U74-AP
Chapter 7: Radio Frequency Distribution System
304