Users Manual Part 1

4 Delete the old CAN Bus unit from the CAN Bus unit mapping list by entering: can
remove_mapping <X>.
<X>
identifies the old unit name and is digit between 0 and 3.
Step example: can remove_mapping dpm 2.
5 Add the new CAN Bus unit to the CAN Bus unit mapping list by entering: add_mapping
dpm<X><track ID>.
<track ID> is a Track ID of the new unit.
<X> identifies the new unit name and is a digit between 0 and 3.
NOTICE: The new unit Track ID is present on the replaced unit label and indicated as
Track ID not mapped.
Step example: can add_mapping dpm 2 JTH0500102
6 View the updated mapping list by entering: can check_mapping.
7 On the mapping list, check that there are no units labeled as Track ID not mapped or
Units are not present.
7.3.4
Hybrid Combiner in MTS 4
For details about the Hybrid Combiner (HC), see Hybrid Combiner
on page 288.
7.3.5
Post Filter
The Post Filter supports non-duplexed configurations. The Post Filter incorporates a DPM. A Post
Filter is only available for the MTS 4 because the MTS 2 does not support non-duplexed
configurations.
The bandwidth is 5 MHz on 400 MHz, 6 MHz on 260 MHz, and 19 MHz on 800 MHz.
6802800U74-AP
Chapter 7: Radio Frequency Distribution System
300