Users Manual Part 1

7.2.2.1.4
Reinstalling the Preselector – MTS 2
Procedure:
1 Slide the Preselector into the filter tray in the cabinet. Make sure the rear center tab fits into the
appropriate slot.
2 While supporting the Preselector fasten the two screws at the front.
3 Fasten the screw in the center tab behind the antenna.
4 Attach all RX, TX and signal cables to the Preselector. Fasten the antenna cable.
5 Switch ON the Power Supply Unit.
7.2.3
MTS LiTE / MTS 2 Duplexer
The Duplexer is a Preselector with Integrated Receiver Multicoupler (RMC) and a Post Filter with a
digital power monitor (DPM) combined into one unit. These form the two bandpass filters that make up
the Duplexer; one is a receive filter and the other a transmit filter.
NOTICE: The MTS LiTE Duplexer is common with the MTS 2 Duplexer.
6802800U74-AP
Chapter 7: Radio Frequency Distribution System
284