Users Manual Part 1

region is used for normal operation, while the default region is a backup from where the settings are
recovered in a memory fault (incorrect checksum) detected in the working region.
Procedure:
To backup the current data from the working region and save it into the default region, use the
following commands at the command prompt:
• sfcp -ocontrol -sworking -ddefault
• sfcp -oex1 -sworking -ddefault
• sfcp -opa1 -sworking -ddefault
• sfcp -orxch1 -sworking -ddefault
6802800U74-AP
Chapter
6: Configuration and Testing
273