Users Manual Part 1

CAUTION: The following command keys the transmitter. Make sure that transmission only
occurs on licensed frequencies or into a dummy load.
Procedure:
1 At the Test Application prompt, type: power -otxch1 -a35 to set the transmitter output to
maximum rated output.
The following figure shows the transmitted signal on the Spectrum Analyzer.
Figure 135: Spectrum Analyzer Display of Transmitted Signal
-120.0
-110.0
-100.0
-90.0
-80.0
-70.0
-60.0
-50.0
-40.0
-30.0
-20.0
-10.0
0.0
394.950 394.962 394.975 394.987 395.000 395.012 395.025 395.037 395.050
Frequency, MHz
dB
RBW = 300 Hz
Span = 0.10 MHz
TEBTS062
012297JNM
2 At the prompt, type: power -otxch1 -a0 to stop RF transmission.
3 Repeat this procedure for each base radio.
6.5.5
Synchronizing Non-Volatile Memory (NVM) Regions
After introducing major changes in the Non-Volatile Memory (NVM) settings, Motorola Solutions
recommends to synchronize NVM regions using the commands described below. Each physical NVM
object has two copies of its contents called the working region and the default region. The working
6802800U74-AP
Chapter 6: Configuration and Testing
272