Users Manual Part 1

NOTICE: To get help, use the following command: SC: pm_config -
If Expansion cabinet is used, pm_config needs to be setup accordingly. By default, the
following commands could be used:
• pm_config br 5 dpm 2
• pm_config br 5 atcc 3 cav 1
• pm_config br 6 dpm 2
• pm_config br 6 atcc 3 cav 2
• pm_config br 7 dpm 2
• pm_config br 7 atcc 4 cav 1
• pm_config br 8 dpm 2
• pm_config br 8 atcc 4 cav 2
To set up pm_config for MTS-2 with one TX antenna, use the following commands:
• pm_config br 1 dpm 1
• pm_config br 2 dpm 1
3 To configure the DPM and ATCC mapping to BR, type pm_config [-?].
4 To configure the ATCC (cavity) to BR mapping, type br <br> atcc <atcc> cav
<cavity>.
5 To configure the DPM to BR mapping, type br
<br> dpm <dpm>.
6 To clear the mapping for a given BR, type -invalidate <br>.
7 To clear all mapping, type -invalidate.
8 To print all mapping, type -print.
6.5.4
Station Verification Procedures
Station verification procedures cover methods to verify transmit and receive operations after the Base
Radio module installation or replacement. Each section contains the equipment setup and the
procedure.
6.5.4.1
Verifying the Base Radio Software Revision
Procedure:
1 Log on to the Base Radio Application using the procedure Logging on to the Base Radio
Application through Serial Connection
on page 241.
2 Enter the command
ver
to check current versions of your Base Radio applications.
3 Log on to the Test Application of the Base Radio using procedure Logging on to the Test
Application
on page 242.
4 Collect revision numbers from the BR by typing: fv -oplatform.
5 Note down the test application software version and then see the System Software Release
Note for the correct software version number.
6 To exit BR Test Application mode, reset the BR using the following command from the MMI:
reset -oplatform
6802800U74-AP
Chapter 6: Configuration and Testing
260