Users Manual Part 1

NOTICE: Configure the Base Radio VSWR only for Base Radios in BR-Arch-1 configuration.
Procedure:
1 Log on to the Base Radio in application mode. For the logging procedure, see Logging on to the
Base Radio Application through Serial Connection on page 241.
2 Type get nvm_param pa max_prev and press Enter
.
The correct value should be 30.
NOTICE: If there is no returned value or the value is incorrect, type
set nvm_param pa max_prev 30
.
3 Type get nvm_param pa dekey_limit and press Enter.
The correct value should be 26.
NOTICE: If there is no returned value or the value is incorrect, type
set nvm_param pa dekey_limit 26
.
6.5.3
Configuring the pm_config
The pm_config command configures DPM and ATCC mapping to Base Radio(s) on the Site
Controller.
For more information about how to use the pm_config command, see MTS Man Machine Interface
Commands Manual.
When and where to use: The pm_config command defines the relationship between RFDS
components and Base Radios. If one cavity in an ATCC measures a high Voltage Standing Wave
Radio (VSWR), it results in the dekey of the corresponding Base Radio. A broken antenna or failure on
a feeder cable indicates a bad VSWR on the DPM. It also results in the decay of Base Radios using
this DPM.
Procedure:
1 Log on to the Site Controller Application. See Logging on to the Site Controller Application
through Serial Connection
on page 240.
2 To set up pm_config for MTS 4 with ATCC and one TX antenna, use the following commands:
• pm_config br 1 dpm 1
• pm_config br 1 atcc 1 cav 1
• pm_config br 2 dpm 1
• pm_config br 2 atcc 1 cav 2
• pm_config br 3 dpm 1
• pm_config br 3 atcc 2 cav 1
• pm_config br 4 dpm 1
• pm_config br 4 atcc 2 cav 2
6802800U74-AP
Chapter 6: Configuration and Testing
259