Users Manual Part 1

6.5.2.3.1.1
Corrective Actions for the BR-Arch-1 Base Radio Receiver Configuration
NOTICE: Use corrective actions only for Base Radio receivers in BR-Arch-1 configuration.
Table 78: Corrective Actions for Missing or Bad Base Radio Parameters in BR-Arch-1 Architecture
Missing or Bad Pa-
rameter
Corrective Action
atten_default
• For MTS 4, enter:
set nvm_param rx1 atten_default 0
• For MTS 2, enter:
set nvm_param rx1 atten_default 4
• If the parameter is missing for MTS 4, add it by entering
set nvm_miss_param rx1 atten_default 0
• If the parameter is missing for MTS 2, add it by entering
set nvm_miss_param rx1 atten_default 4
dekey_limit Enter:
set nvm_param pa dekey_limit 26
rx_dc_inj_usl Enter:
set nvm_param rx1 rx_dc_inj_usl 2.5
rx_dc_inj_lsl Enter:
set nvm_param rx1 rx_dc_inj_lsl 0
ad1_scaling6 Enter:
set nvm_param rx1 ad1_scaling6 28.9
rx_fru_config Enter:
set nvm_param rx1 rx_fru_config <[X]>
where the values for <[X]>
are:
• 1 - Receiver branch 1 enabled
• 2 - Receiver branch 2 enabled
• 3 - Receiver branches 1 and 2 enabled
• 4 - Receiver branch 3 enabled
• 5 - Receiver branches 1 and 3 enabled
• 6 - Receiver branches 2 and 3 enabled
• 7 - Receiver branches 1, 2 and 3 enabled
6.5.2.3.2
Configuring the Base Radio VSWR
When and where to use: The procedure below can be done locally as well as remotely. The
commands to check and change the BR parameters require the use of BRC Application MMI.
6802800U74-AP
Chapter
6: Configuration and Testing
258