Users Manual Part 1
6.5.2.1.2.2
Setting Base Radio IP
It is not recommended to manually configure the position and IP address of a Base Radio. Manual
procedures can be performed only by authorized technical personnel. Use the cccp command for
automatic position and IP address configuration.
Do not perform this procedure after performing Setting and Accessing Base Radio Position by Using
the cccp Command on page 255.
Procedure:
1 Log on to the Test Application. See Logging on to the Test Application on page 242.
2 To configure the IP address of the Base Radio, enter one of the following commands:
• cpp -olan1 -i<IP>
• cpp -olan2 -i<IP>
where <IP>
is the new IP address, for example 10.0.253.11.
IMPORTANT: Do NOT change the original MAC addresses of the Base Radio.
6.5.2.2
Enabling Base Radio Receiver Branches
Every new Base Radio requires enabling receivers. It is possible to separately enable or disable every
branch.
Procedure:
1 Log on to the Base Radio in application mode. See Logging on to the Base Radio Application
through Serial Connection on page 241.
2 Verify if there are any existing settings present. Enter the following command: get nvm_param
rx1 rx_fru_config and press E
NTER.
The branch setting depends on the receiver diversity required for the site.
3 If the Base Radio Application does not return any values, or returns an incorrect setting, fix the
parameter by entering the following command: set nvm_param rx1 rx_fru_config <X>
where <X> is a number corresponding to one of the following settings:
• 1 - Receiver branch 1 enabled
• 2 - Receiver branch 2 enabled
• 3 - Receiver branches 1, and 2 enabled
• 4 - Receiver branch 3 enabled
• 5 - Receiver branches 1, and 3 enabled
• 6 - Receiver branches 2, and 3 enabled
• 7 - Receiver branches 1, 2, and 3 enabled
6.5.2.3
Additional Receiver Configuration for BR-Arch-1
The receivers in BR-Arch-1 Base Radios might require additional parameter modification. The
procedures in this section are applicable only to Base Radios in BR-Arch-1 architecture. Do not
perform these actions in BR-Arch-2 architecture.
6802800U74-AP
Chapter
6: Configuration and Testing
256