Users Manual Part 1

6.5.2.1.1
Setting and Accessing Base Radio Position by Using the cccp Command
Perform this procedure to program the number of the position within a selected cabinet of where a
Base Radio is mounted.
Setting Base Radio position using the cccp command automatically sets the Base Radio IP address.
Procedure:
1 Log on to the Base Radio mode appropriate for your architecture:
• For a Base Radio in BR-Arch-1 architecture, log on to Boot1. See Logging on to the BOOT1
mode
on page 241.
• For a Base Radio in BR-Arch-2 architecture, log on to Base Radio Core. See Logging on to
the Base Radio Core Mode on page 242.
2 At the command prompt, enter: cccp <cabinet><position>
The Base Radio designation starts with the left Base Radio designated as 1.
In the Prime cabinet with two Base Radios, the left Base Radio is designated as 1, and the right
is designated as 2.
Step example:
To set BR Position ID to 2 and Cabinet ID to 1 by using BRC Boot1, enter: cccp 1 2
To set Base Radio position for base radio in MTS 4 Expansion Cabinet by using BRC Boot1,
enter: cccp 2 2
6.5.2.1.2
Manual Configuration of Base Radio Position and IP
It is not recommended to manually configure the position and IP address of a Base Radio. Manual
procedures can be performed only by authorized technical personnel. Use the cccp command for
automatic position and IP address configuration. See Setting and Accessing Base Radio Position by
Using the cccp Command on page 255.
6.5.2.1.2.1
Setting and Accessing Base Radio Position Using Test Application
It is not recommended to manually configure the position and IP address of a Base Radio. Manual
procedures can be performed only by authorized technical personnel. Use the cccp command for
automatic position and IP address configuration.
Procedure:
1 Log on to the Test Application. See Logging on to the Test Application on page 242.
2 Perform the following actions:
• To configure the BR cabinet id, type ci -oplatform -c<n> at the command prompt. <n>
is a number between 1 and 8 corresponding to the cabinet id of the Base Radio.
• To configure BR position, type pi -oplatform -p<n> at the command prompt. <p> is a
number between 1 and 8 corresponding to the position id of the Base Radio.
6802800U74-AP
Chapter 6: Configuration and Testing
255