Users Manual Part 1

Figure 133: BRC Indicators

BASE RADIO

FRONT VIEW

BASE RADIO

Service

Rx 1

DC in

AUX

Status

Alarm

SC2

SC1

Rx 2

Rx 3

Reset

6.5.2

Base Radio Position and Receivers Selection

The new Base Radio needs to be assigned a position identifier. This operation is performed from the

Service port.

Use the MMI commands to:

• Set the position identifier of the Base Radio within the cabinet. See Setting and Accessing Base

Radio Position by Using the cccp Command on page 255.

• Set the number of active receivers (diversity) of the new Base Radio. See Enabling Base Radio

Receiver Branches on page 256.

• BR-Arch-1 Base Radios only: Verify and configure additional receiver parameters. See Additional

Receiver Configuration for BR-Arch-1 on page 256.

For detailed information on the MMI commands, see the MTS Man Machine Interface Commands

Manual.

6802800U74-AP

Chapter 6: Configuration and Testing

253