Users Manual Part 1

In-
dex
Cable
Part
Number
From Unit To Unit Notes
bers on
page 204
18 See Table
62: TX
ATCC
Phasing
Harness
Part Num-
bers on
page 217
ATCC (3, 4) ATCC (1, 2)
Prime Cabinet
TX path, Phasing Harness rout-
ed through conjunction hole at
side of cabinet
19 3066543B
11
RX Splitter 1 /
Prime Cab
Duplexer /
Exp Cab (in
MTS 4 Prime
Cabinet)
RX path/ RX on 1 or 2 ant.
20 3066543B
11
RX Splitter 2 /
Prime Cab
Preselector
1 / Exp Cab
(in MTS 4
Prime Cabi-
net)
RX path/ RX on 1 or 2 ant.
21 3066543B
11
RX Splitter 3 /
Prime Cab
Preselector
2 / Exp Cab
(in MTS 4
Prime Cabi-
net)
RX path/ RX on 2 ant.
NOTICE:
In the Prime Cabinet, detach the Duplexer Tx cable in the prime cabinet from the T connector
on the Interconnect Harness in the prime. Connect the free end of the Phasing Harness from
the expansion cabinet to the T connector on the Interconnect Harness in the prime cabinet and
connect the Duplexer Tx cable to the T connector in the Phasing Harness. This way all eight
channels are connected to a single Duplexer.
When Manual Tune Cavity Combiner (MTCC) is used instead of Auto Tune Cavity Combiner
(ATCC), connect the cables to corresponding inputs and outputs.
RX cables from Filters in Prime Cabinet to RX Splitters in the Expansion Cabinet are routed
through holes on the back side of the top-lid.
6802800U74-AP
Chapter 5: Interconnection and Internal Cabling
216