Users Manual Part 1

4 Connect the Link1 and Link2 outputs on the Ethernet Y Splitter to the Site Controller by using
the Ethernet cables as described in Table 44: Ethernet Site Link Cabling for MTS 2 on page 184
and Figure 102: Ethernet Site Link Cabling for MTS 2 on page 185.
4.10.1.2
Connecting Ethernet Site Link Retrofit Kit for MTS 2 (new JP)
Procedure:
1 Bend open and connect the open Link1 connector on the Junction Panel with the RJ45 coupler
(3066562B01).
2 Bend open and connect the open Link2 connector on the Junction Panel with the RJ45 coupler
(3066562B01).
3 Connect the
Link1 and Link2 outputs on the Ethernet Y Splitter to the Site Controller by using
the Ethernet cables as described in Table 44: Ethernet Site Link Cabling for MTS 2 on page 184
and Figure 102: Ethernet Site Link Cabling for MTS 2 on page 185.
4.10.1.3
Connecting Ethernet Site Link Retrofit Kit for MTS 4
Unlike the MTS 2, the previous type of MTS 4 Junction Panel has an unused AUX breakout which will
be used, together with the existing E1 connector, for Ethernet Site Link functionality.
When and where to use:
Follow this procedure to gain Ethernet Site Link functionality from the E1 and AUX connectors on the
previous type of MTS 4 Junction Panel.
Procedure:
1 Remove existing E1 cable from E1 connector on Junction Panel.
2 Connect the open E1 connector on the Junction Panel with the RJ45 coupler (3066562B01).
3 Bend AUX breakout and insert the second RJ45 coupler (3066562B01).
4 Attach remaining cables.
• For configurations with single Site Controller, follow Table 45: Ethernet Site Link Cabling for
MTS 4 with Single Site Controller on page 186 and Figure 103: Ethernet Site Link Cabling for
MTS 4 with Single Site Controller on page 187 for further cabling and connections.
• For configurations with dual Site Controller, follow Table 46: Ethernet Site Link Cabling for
MTS 4 with Dual Site Controller on page 188 and Figure 104: Ethernet Site Link Cabling for
MTS 4 with Dual Site Controller on page 189 for further cabling and connections.
NOTICE: In Table 45: Ethernet Site Link Cabling for MTS 4 with Single Site Controller on
page 186 and Table 46: Ethernet Site Link Cabling for MTS 4 with Dual Site Controller on
page 188; and
Figure 103: Ethernet Site Link Cabling for MTS 4 with Single Site
Controller on page 187 and Figure 104: Ethernet Site Link Cabling for MTS 4 with Dual
Site Controller on page 189E1 on old Junction Panel is equivalent to Link1 and AUX on
old Junction Panel is equivalent to Link2.
4.10.1.4
Connecting Ethernet Site Link Retrofit Kit for MTS 4 with Expansion
Cabinet (old JP)
When and where to use:
6802800U74-AP
Chapter 4: Hardware Installation
150