Users Manual Part 1

Figure 59: Base Radio Antenna Connections – MTS 4
RX1/TX1 or TX1
RX3
RX2/TX2 or TX2
RX2
RX1
The antenna leads should be dropped above the MTS cabinet as per the site plan. It is assumed that
the Base Radio antennas have been installed before and that the RFDS section is properly configured.
(If required, refer to chapter Interconnection and Internal Cabling on page 163, section RF Cabling on
page 193 for RF cabling diagrams.)
Identify and tag all antenna cables designated for connection to the MTS. Be sure to document this
information for future use.
6802800U74-AP
Chapter 4: Hardware Installation
128