Users Manual Part 1

b Two spare Ø6 terminals for 16 mm
2
cable are included. Special crimp tool applies on fitting
these (not included).
c Click the protection cap on. Additional break away windows are available on cap allowing
multiple entry of cables.
NOTICE: Make sure no damage are done on cables by sharp edges on the cap.
d Check that cables are secured properly and tighten the included cable tie retainers.
WARNING: Be very careful not to short circuit the battery poles.
NOTICE: The cables shall not touch the metal housing.
Figure 52: MTS LVD Kit Battery Cable Connections
3 Note the small + and – signs on the side of the relay. The pole with the – sign is recommended
to be connected to the – pole on the battery.
Figure 53: MTS LVD Kit Plus and Minus Signs
4 Flip the backplate by hand, and insert the 2 rivet plugs as in the following figure.
6802800U74-AP
Chapter 4: Hardware Installation
123