Users Manual Part 1

Figure 42: 100–240 VAC Connections on the Expansion Cabinet Junction Panel
4.5.3.4
Connecting 100–240 VAC Power Source to Equipment Cabinet
WARNING: Make sure all power to the Power Supply Unit is switched off to prevent accidental
contact with high energy and injury to personnel.
Procedure:
1 Connect the AC cable to the AC socket (type IEC C15 line socket, Motorola P/N 3166502A01),
which is provided with the MTS.
2 Insert the AC socket into the AC input connector on the MTS and fix with the retaining clip as
shown in the following picture. This fixture will only work with the supplied IEC connector.
6802800U74-AP
Chapter 4: Hardware Installation
114