Users Manual Part 1

2 Bring the MTS in position and lower it onto the mounting plate. Care must be taken not to lower
the MTS onto the locating tabs on the rear of the mounting plate to avoid bending.
3 Move the MTS from the front to the back ensuring that the leveling feet of the MTS locate in the
corresponding slots in the mounting plate.
4 Secure the MTS on the mounting plate using the two front security M10 screws. If the leveling
feet are in the lowest position, M10x40 screws must be used. The position of the screws is
shown in Figure 24: Position of Security Screws on page 100. Recommended tool: allen wrench
for M10, SW8 HEX screws (supplied with the mounting plate kit).
Figure 24: Position of Security Screws
Security Screws
4.4.5
Wall Fixing
The MTS 4 and Expansion Cabinet have the option of being fixed to a wall for extra stability. To do
this, use the two M6 holes in the back of either the MTS 4 cabinet or the Expansion Cabinet. See the
following figure.
6802800U74-AP
Chapter 4: Hardware Installation
100