Service Manual

95
6802800U74-AN
Chapter 4: Hardware Installation
Figure 21: MTS LiTE/MTS 2 – Drill Hole Position for the Mounting Plate
Figure 22: MTS 4 – Drill Hole Position for the Mounting Plate
3 Secure all mounting locations using nuts and lock washers.
4 Fully tighten all mounting nuts securing the mounting plate to the floor.
4.4.4.3
Securing Cabinet to a Mounting Plate
Procedure:
1 Move the MTS cabinet near to the mounting plate which has been fixed to the floor as described
before.
2 Bring the MTS in position and lower it onto the mounting plate. Care must be taken not to lower
the MTS onto the locating tabs on the rear of the mounting plate to avoid bending.
3 Move the MTS from the front to the back ensuring that the leveling feet of the MTS locate in the
corresponding slots in the mounting plate.
4 Secure the MTS on the mounting plate using the two front security M10 screws. If the leveling
feet are in the lowest position, M10x40 screws must be used. The position of the screws is
shown in Figure 23: Position of Security Screws on page 96. Recommended tool: allen wrench
for M10, SW8 HEX screws (supplied with the mounting plate kit).