Service Manual

6802800U74-AN
Chapter 13: MTS Troubleshooting
384
Alarm ID
Descrip-
tion
callback set
in BRC Ap-
plication -
internal
software er-
ror
ALM_PLAT_NO_GEN_CB No CoreLib
command
complete
callback set
in BRC Ap-
plication -
internal
software er-
ror
ALM_PLAT_NO_EVT_CB No CoreLib
event call-
back set in
BRC Appli-
cation - in-
ternal soft-
ware error
ALM_PLAT_NO_RF_CB No CoreLib
DSP re-
ceive /
transmit da-
ta callback
set in BRC
Application
- internal
software er-
ror
Recovery
Action
by the soft-
ware.
No recovery
action taken
by the soft-
ware.
No recovery
action taken
by the soft-
ware.
No recovery
action taken
by the soft-
ware.
Clear Ac-
tion
after reset-
ting BRC.
The alarm is
cleared only
after reset-
ting BRC.
The alarm is
cleared only
after reset-
ting BRC.
The alarm is
cleared only
after reset-
ting BRC.
Notes
Software error
Software error
Software error
ALM_TX_FINAL_FAIL-
URE_FLT
Power Am-
plifier final
failure.
BRC is de-
keyed by the
software.
If the alarm
condition
disappears
the alarm is
cleared.
The alarm may
be reported be-
cause of the
BRC hardware
failure or config-
uration prob-
lems.
ALM_TX_FINAL_FAILURE Power Am-
plifier final
failure.
The output
power is re-
duced by the
software.
If the alarm
condition
disappears
then the out-
put power is
restored by
the software
to the target
level.
The alarm may
be reported be-
cause of the
BRC hardware
failure or config-
uration prob-
lems.