Service Manual

ManualsBrandsMotorola Solutions ManualsElectronicsNon Broadcast Transmitter

6802800U74-AN

Chapter 13: MTS Troubleshooting

378

Alarm ID

Descrip-

tion

Recovery

Action

Clear Ac-

tion

Notes

• ALM_TX_CLIP_DE-

TECT_ALM_FAULT

• LM_TX_CLIP_DE-

TECT_FAULT

• ALM_TX_CLIP_DE-

TECT_ALM_WARN

• ALM_TX_CLIP_DE-

TECT_WARN

ALM_TX_TEMP_INTER-

NAL_WARN

• ALM_TX_TEMP_INTER-

NAL_FAULT

• ALM_PA_TEMP_INTER-

NAL_WARN

• ALM_PA_TEMP_INTER-

NAL_FAULT

Reported

when Jave-

lin clip de-

tected fail-

ure condi-

tion still ex-

ists after 1

minute.

Exciter Jav-

elin clip de-

tected.

Internal

Power Am-

plifier tem-

perature is

too high.

Internal

Power Am-

plifier tem-

perature is

too high.

BRC is de-

keyed by the

software.

The output

power is re-

duced by the

software.

The output

power is re-

duced by the

software.

BRC is de-

keyed by the

software.

BRC is re-

keyed by the

software. If

the alarm

condition

disappears

after key-up

then the

alarm is

cleared. If

the alarm is

reported for

the third time

it cannot be

cleared until

next BRC re-

set.

If the alarm

condition

disappears

then the out-

put power is

restored by

the software

to the target

level. If the

alarm is re-

ported for

the third time

it cannot be

cleared until

next reset.

If the alarm

condition

disappears

then the out-

put power is

restored by

the software

to the target

level.

If the alarm

condition

disappears

the alarm is

cleared and

BRC can be

re-keyed

again.

The alarm may

be reported be-

cause of the

BRC hardware

failure or config-

uration prob-

lems.

The alarm may

be reported be-

cause of the

BRC hardware

failure or config-

uration prob-

lems.