Service Manual

223
6802800U74-AN
Chapter 6: Configuration and Testing
diagnostic tests. MMI commands also provide a means to configure the site controller and base
radio(s) for intended operation, and to enable various system tests.
The testing of the MTS by using the MMI can be done in Test Application Mode or with sets of
commands available for Site Controller and Base Radio.
The complete set of MMI commands, including both Site Controller and base radio commands, is
defined in the MTS MMI Commands Manual.
The MTS Site Controller has the following modes of operation:
• BOOT1 – see Logging on to the BOOT1 mode on page 224.
• Test Application – see Logging on to the Test Application on page 225.
• Site Controller Application – if the boot process is not interrupted, this is the default mode of
operation. See Logging on to the Site Controller Application through Serial Connection on page
223.
The MTS Base Radio modes of operation are dependent on its architecture:
Table 73: MTS Base Radio Modes of Operation
BR-Arch-1 Modes BR-Arch-2 Modes
BOOT1
Logging on to the
BOOT1 mode on
page 224
Base Radio Core
Logging on to the
Base Radio Core
Mode on page 225
Test Application
Logging on to the
Test Application on
page 225
Test Application
Logging on to the
Test Application on
page 225
Base Radio Applica-
Logging on to the
Base Radio Applica-
tion
Logging on to the
Base Radio Applica-
tion through Serial
Connection on page
224
tion (if the boot proc-
Base Radio Applica-
ess is not interrupted,
tion through Serial
this is the default
Connection on page
mode of operation)
224
Each of these modes contains a different set of the Man Machine Interface Commands.
CAUTION: The Test Application mode is a powerful mode. Inappropriate use of the Test
Application MMI can lead to a permanent hardware failure. Proceed with extreme caution.
6.2.1.1
Logging on to the Site Controller Application through Serial Connection
Procedure:
1 Connect the port RS232 of the Service Terminal with the Site Controller RJ45 Service Port using
the Service Cable.
See Service Cable and Connector Box Description on page 227 for more information about the
Service Cable.
2 On the Service Terminal start the BTS Service Software application, select the proper MTS type
and log on.
3 In the Configuration → Direct Settings → Direct Serial Port Settings menu, verify the correct
settings:
• Port: The appropriate serial port is selected.
• Speed: 19200 baud