User's Manual

11 See Configuring Centralized Authentication on Devices in VoyenceControl on page 152 to program the base
radio using UNC.
General Safety Precautions
Warning: Compliance with FCC guidelines for human exposure to Electromagnetic Energy (EME) at
Transmitter Antenna sites generally requires that personnel working at a site must be aware of the potential
for exposure to EME, and can exercise control of exposure by appropriate means, such as adhering to
warning sign instructions, using standard operating procedures (work practices), wearing personal
protective equipment, or limiting the duration of exposure. For more details and specific guidelines, see
“Appendix A” of the Motorola Standards and Guidelines for Communications Sites manual.
Observe the following general safety precautions during all phases of operation, service, and repair of the equipment
described in this manual. Follow the safety precautions listed and all other warnings and cautions necessary for the
safe operation of all equipment. See the appropriate section of the product service manual for additional pertinent
safety information. Due to the danger of introducing additional hazards, do not install substitute parts or perform any
unauthorized modifications of equipment.
Note: The installation process requires preparation and knowledge of the site before installation begins.
Review installation procedures and precautions in the Motorola Standards and Guidelines for
Communications Sites manual before performing any site or component installation.
Always follow all applicable safety procedures, such as Occupational Safety and Health Administration (OSHA)
requirements, National Electrical Code (NEC) requirements, local code requirements, and safe working practices.
Also, all personnel must practice good judgment. General safety precautions include the following:
• Read and follow all warning notices and instructions marked on the product or included in this manual before
installing, servicing, or operating the equipment. Retain these safety instructions for future reference.
• If troubleshooting the equipment while power is on, be aware of the live circuits.
• Do not operate the radio transmitters unless all RF connectors are secure and all connectors are properly
terminated.
• Ground all equipment properly in accordance with the Motorola Standards and Guidelines for Communications
Sites manual and specified installation instructions for safe operation.
• Slots and openings in the cabinet are provided for ventilation. Do not block or cover openings that protect the
devices from overheating.
• Only a qualified technician familiar with similar electronic equipment should service equipment.
• Some equipment components can become hot during operation. Turn off all power to the equipment and wait until
sufficiently cool before touching.
•
Maintain emergency first aid kits at the site.
• Direct personnel to call in with their travel routes to help ensure their safety while traveling between remote sites.
• Institute a communications routine during certain higher risk procedures where the on-site technician continually
updates management or safety personnel of the progress so that help can be dispatched if needed.
• Never store combustible materials in or near equipment racks. The combination of combustible material, heat, and
electrical energy increases the risk of a fire safety hazard.
• Equipment installed at the site meeting the requirements of a "restricted access location," per UL60950-1, is
defined as follows: "Access can only be gained by service persons or by a user who has been warned about the
possible burn hazard on equipment metal housing. Access to the equipment is by using a tool or lock and key, or
other means of security, and is controlled by the authority responsible for the location."
Warning: Burn hazard. The metal housing of the product may become extremely hot. Use caution when
working around the equipment.
86 | GTR 8000 Base Radio Installation
Send Feedback | November 2013 | 6871024P71-A
Applicant: Motorola Solutions
Equipment Type: ABZ89FC5810B / 109AB-5810B
Exhibit D (Permissive Change)