User's Manual

APPLICANT: MOTOROLA SOLUTIONS EQUIPMENT TYPE: ABZ89FC5810B
109AB-5810B
EXHIBIT D1-1
User / Operational Manual
Manual Front Matter (Draft, Continued)
Warning Label on Hot Modules
All Tx and Rx RF cables' outer shields must be grounded per Motorola Standards and Guidelines for
Communications Sites manual requirements.
DC input voltage shall be no higher than 60VDC.This maximum voltage shall include consideration of the battery
charging "float voltage" associated with the intended supply system, regardless of the marked power rating of the
equipment. Failure to follow this guideline may result in electric shock.
All Tx and Rx RF cables shall be connected to a surge protection device according to the Motorola Standards and
Guidelines for Communications Sites manual. Do not connect Tx and Rx RF cables directly to outside antenna.
RF energy burn hazard. Disconnect power in the cabinet to prevent injury while disconnecting and connecting
antennas.
GTR 8000 Base Radio Supplemental Safety Installation Requirements
The Supplemental Safety and Installation Requirements include the following:
 The GTR 8000 Base Radio must be installed in a suitable, in-building enclosure. A restricted access location is
required when installing this equipment into the end system.
 The base radio contains a Class 1 built-in power supply component. This component is equipped with an
appliance inlet for connecting to an AC input, as well as DC input terminals which meet SELV DC circuit
requirements.
 When installing the equipment, all requirements of relevant standards and local electrical codes must be
fulfilled.
 The maximum operating ambient temperature of this equipment is 60°C. The maximum operating altitude is
3000 meters above sea level.
 The 28.6 VDC output from the power supply to the PA is at an energy hazard level (exceeds 240 VA). When
installing into the end system, care must be taken so as not to touch the output wires.
 When the GTR 8000 Base Radio / Repeater is used in a DC reverting system, the DC power supply must be
located in the same building as the GTR 8000 Base Radio, and it must meet the requirements of a SELV circuit.