User Manual

Canopy 900 MHz AP and SM User Guide
Issue 1, Draft 1 June, 2004 Page 12 of 16
The attributes of one of these certified antennas (shown in Figure 4: Additional 900 MHz Flat Panel
Antenna) is as follows:
• 10 dBi gain
• 12"x12"x1" (305x305x25 mm)
• 3.3 lbs (1.5 kg)
• vertical or horizontal polarization
• female N-type connector)
• 3 dB beam width 60° vertical and 60° horizontal
Figure 4: Additional 900 MHz Flat Panel Antenna
Operation
Important! Use of connectorized antennas requires professional installation. The professional installer
is responsible for
• Selection of an antenna approved for use with the Canopy 900 MHz AP and SM by the national
regulatory agency
• Setting of the gain consistent with the antenna and within regulatory limits
• Use of moisture sealant to increase long-term reliability of the connectorized connection
Enter the dBi gain of your antenna in the Antenna Gain parameter on the AP Configuration page, as shown
in Figure 2: Highlights of 900 MHz AP Configuration Page.
For this antenna:
Enter this Antenna Gain:
900 MHz Flat Panel antenna available through
Motorola
10 dBi
Additional Flat Panel antennas certified with
regulatory agency by Motorola
10 dBi
Antenna certified by third party
Consult antenna documentation