User's Manual

AP_CMM2 User Manual Issue 4 Draft Pa
g
e 47 of 48
ACCESS POINT MODULE
Operating Frequency Ranges 2.4 Modules: ISM 2.4 to 2.4835 GHz
5.2 Modules: U-NII: 5.25 to 5.35 GHz
5.7 Modules: ISM: 5.725 to 5.850 GHz
Access Method TDD/TDMA
Signaling Rate 10 Mbps
Modulation Type High Index 2-level Frequency Shift Keying (FSK)
(Optimized for interference rejection)
Carrier to Interference (C/I) 3dB nominal
Receiver Sensitivity -83dBm 10
-4
BER
Operating Range Up to 15 miles (24 km) with passive reflector in the 2.4
GHz band. Up to 2 miles (3.6 km) with integrated
antenna in the 5.2 GHz band. Up to 10 miles (16 km)
with passive reflector in the 5.7 GHz band.
Transmitter Power Meets FCC U-NII/ISM and IC LELAN ERP Limit
DC Power measured at DC converter 0.3A @ 24 VDC (7.2 watts) typical
0.35 A @ 24 VDC (8.4 watts) max (long cable runs, high
ambient temperature, high transmit ratio (set by
downlink percentage))
Interface 10/100 BaseT, half/full duplex
Rate auto negotiated (802.3 compliant)
Protocols Used by CANOPY IPV4, UDP, TCP, ICMP, Telnet,
HTTP, FTP, SNMP, DES
Protocols Supported by Canopy Switched Layer 2 Transport with support for all common
Ethernet protocols including IPV6, NetBIOS, DHCP,
IPX, etc.
Software Upgrade Path Remotely downloaded into flash memory
Network Management HTTP, TELNET, FTP, SNMP
Operation Temperature
-40°F to +131ºF (-40°C to +55°C)
Weight 1 lb. (.45kg)
Dimensions 11.75” H x 3.4” W x 3.4” D (29.9 cm H x 8.6 cm W x 8.6
cm D)
CLUSTER MANAGEMENT MODULE GEN II
PHYSICAL
Max length from Cluster Management Module
to any radio
328 cable feet (100 meters)
Max length from Cluster Management Module
to GPS antenna
100 cable feet (30.5 meters)
Dimensions
17.00” H x 12.88” W x 6.50” D
(43.18 cm H x 32.72 cm W x 16.51 cm D)
Weight 25.0 lbs. (11.3 kg)
Operation Temperature -40°F to +131°F (-40°C to +55°C)
Overall Meets CE IP44 according to EN60529:2000